The V120's adjustable miter bar will fit square-sided miter slots 3/4" wide, 3/8" deep, and either with or without a 15/16" wide T-slot at the bottom. The miter bar's adjustment range accommodates slot widths between 0.740" to 0.760". Doubles Any Miter Gauge's Crosscut Capacity to 24" and Securely Holds Even the Smallest Workpieces for Safe Accurate Cuts

The Incra MITER1000 SE features a 3/4" x 3/8” steel miter bar with up to six expandable nylon rings to achieve an absolutely perfect fit in any standard miter gauge slot. For adequate support laterally, the Miter 5000 requires a minimum of 254mm (10") from the side of the outer edge of the miter slot to either the left or right edges of the saw (sled can be installed on either side of the blade). Shown here with optional INCRA Miter Gauge. Miter Gauge not included! Blade cover removed for demonstration purposes. Do not work without blade cover! While the V27 delivers ALL the accuracy of its bigger INCRA Miter Gauge brothers, its no-nonsense design and compact size make it the most affordable INCRA Miter Gauge EVER! Now, the INCRA Miter V27 makes it possible to put an INCRA Miter Gauge in EVERY standard miter channel in your shop. Craftsman, imports, etc. An excellent fit in the channel directly transfers the Miter 1000HD's incredible accuracy directly to your project.Flip Fences can be used with any INCRA Miter Gauge and the Flip Shop Stop. Flip Fences are NOT compatible with the standard Shop Stop.

Six expansion disks adjust both sides of the bar for ZERO side play, low-friction travel on all table saws with standard miter gauge channels, including Delta, Craftsman, imports, etc. An excellent fit in the channel directly transfers the Miter 1000HD's incredible accuracy to your project. The Miter 1000's adjustable miter bar will fit square-sided miter slots measuring 3/4" wide, 3/8" deep, and with or without a 15/16" T-slot at the bottom. The miter bar's adjustment range accommodates actual slot widths between 0.740" and 0.765".The Special Edition Miter1000 comes standard with Incra’s finest cross cut fence, the FlipFENCE and FlipSTOP. The unique design of this fence guarantees a perfect stop point for mitered board ends. When in the stop position, both flip arms fully engage the front surface of the fence, thus preventing the board tip from slipping behind the stop. Don't let the small size fool you! The NEW Miter V120 puts high-resolution, repeatable accuracy within the budget of every woodworkers. An incredible 120 angle stops are laser cut into the steel protractor, with a stop available for every whole degree and two special stops at 22.5 degrees for cutting eight-sided frames and mouldings.